IBM 3745 Problem Determination Manual page 347

Wrap Test
9
--------------------------------------------------------------------------------- m m/ddlyy h h : m m
FUNCTION ON SCREEN: WRAP TEST
WRAP PATTERN SELECTION
LINE ADDRESS: 2
LCD C: BSC EBCDIC
TYPE: DATA
CNTRL PGH: NCP
- TEST IN TRANSPARENT MODE (Y,N)
==>
~.'
- EIB OR ITB HODE (V,N)
==>
II
- SELECT ONE
opn
ON (1 TO 3) ==>
II
1
=
USE DEFAULT PATTERN
2
=
0 I SPLA V DEFAULT PATTERN
3 = CREATE PERSONAL PATTERN
THEN PRESS SEND
===>
LEVEL: LIC
LIC TYPE: 3
Fl :END F2:MENU2 F3:ALARM F5:CANCEL
• Type
0
or
0
if lines
fl
and
0
are displayed:
fl
According to the LCD value, one of the following may be displayed:
TEST IN TRANSPARENT MODE (Y,N)
= = >
(I n transparent mode, control characters are considered as data.)
TRANSPARENT MODE IS NOT SUPPORTED
When you defined the line in emulation mode or in NCP-ASCII.
ONLY TRANSPARENT MODE IS SUPPORTED
When you defined the line in EP-ASCII (LCD
=
E).
LCD has been defined at control program generation and LCD
=
E means
SSC ASCII TRSP.
o
In BSC only, the following is displayed:
EIB or ITS MODE (Y,N)
= = >
- In NCP, if you enter Y, ITBs will be taken as control characters and not
as data in your personal pattern (there is no ITS in default patterns).
- In EP, if the line has been defined in ITS mode at generation, enter Y .
• On line
II:
~
[
I
SEND)
to select default pattern.
• The next screen is displayed.
16-4
IBM 3745 Communication Controller: Problem Determination Guide
o