IBM 3745 Problem Determination Manual page 292

o
o
o
o
o
LIC Messages (LICS)
The following
LIe
messages are displayed on the PKD. The cause and the recommended corrective
action are given. Perform the corrective actions step by step until the error is cleared.
CONFIG MISMATCH
Cause:
Local LlC and remote modem configuration
Action:
• Check the local configuration.·
• Ask the remote operator to check the remote configuration.
• Reconfigure if necessary, see the 3745 Connection and Integration Guide.
• Press the EXIT key to return to the background display.
LOC MODEM ERROR
Cause:
Local LlC error.
Action:
• Verify that the telecommunicati.on wrap is correctly plugged.
• Replace the LlC, then go back to step 6 on page 9-34.
• Press the EXIT key to return to the background display.
LOC DTE ERROR
MASTER ONLY
Cause:
• There has been no data transmission within the past 15 minutes.
• System fault.
Action:
• Try automatic problem determination again during normal data transmission.
• Contact the host operator to check that the line is activated.
• Press the EXIT key to return to the background .display.
Cause:
You are attempting to run the test from a remote secondary or tributary Lle5.
Action:
• If, at the remote side, the control (or primary) point is:
A LlC5, ask the remote operator to run LLAP.
Another equipment, ·ask the remote operator to execute a similar problem determination
procedure or check the remote equipment.
• Press the EXIT key to return to the background display.
Chapter 9. LlC and Line Problems '(LSS)
9-41