Wall Mounting - ZyXEL Communications VMG4005-B50B User Manual

lose all configurations that you had previously and the password will be reset to the factory default (see
the device label).
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for more than five seconds
2
or until the POWER LED begins to blink and then release it.
When the POWER LED begins to blink, the defaults have been restored and the device restarts.

1.4.5 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 2 Wall Mounting Information
Distance between holes
Screws
Screw anchors (optional)
The following figure introduces the specifications of the screws and screws anchors for wall mounting.
Figure 4 Screws & Screw Anchors Specifications
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Do NOT wall-mount the VMG over the height of 2 meters.
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Chapter 1 VMG Introduction
80 mm
Two
Two
VMG4005-B50B User's Guide
11