Table of Contents
Advertisement
Trunk Programming
Trunk Programming
Defaulting a Trunk
Setting a Trunk's Call Control Plan
Setting a Trunk's Directory Name & Identification
Programming Manual
INDeX 9.1
You can reset the details for an individual trunk back to the default trunk values.
Note: You can also program the default trunk settings by entering DEFAULT rather
than a directory number when entering the Trunk menu.
To default a trunk :
1. From the Administration menu, select Trunk and enter the trunk's directory
number.
2. Select Default record.
Call Control Plans contain a range of settings to control how the INDeX routes calls
(see "Call Control Plans" on page 41). The same call control plan can be shared by
several trunks that require the same call routing settings. Trunks can also be
directed to pilot numbers, such that incoming trunk calls can take advantage of that
pilot numbers settings, e.g. call Limiting on non-DDI calls (see page 40).
To set a trunk's call control plan :
1. From the Administration menu, select Directory.
2. Select Trunk and enter the trunk's directory number.
3. Select Call control plan and enter the plan that the trunk should use.
4. If required, enter a Pilot number. If a pilot number is specified here, then the
call control plan number on this menu is replaced with the call control plan
numbers specified on the pilot number menu (see page 40).
The trunk's directory name is displayed on suitable terminals during a call using
that trunk. However the name displayed during the call can also be taken from
several other sources (see "Alpha Tagging" on page 95).
You can also give each trunk an identification name. The INDeX uses the
identification name within its own programming menus and reports.
To set a trunk's identification :
1. From the Administration menu, select Trunk and enter the trunk's directory
number.
2. Select Identification and enter a name of up to 15 characters.
To set a trunk's directory name :
1. From the Administration menu, select Directory.
2. Select Trunk and enter the trunk's directory number.
3. Select Name and enter a name of up to 16 characters.
4. Select Sort on last name and set how the name should be used in the INDeX
function.
Trunk Programming - Page 46
38DHB0002UKDJ – Issue 3 (12/00)
Page 46
Advertisement
Table of Contents
