Table of Contents
Advertisement
Page 38 - Enabling DDI on a Trunk
Enabling DDI on a Trunk
Trunk ARS Settings
Page 38 - DDI & Pilot Numbers
38DHB0002UKDJ – Issue 3 (12/00)
For an incoming call to ignore the trunk menu settings and use DDI routing, you
must specify that trunk as a DDI Line. The trunk provider must also set that trunk to
provide DDI digits.
To set a trunk to DDI operation :
1. From the Administration menu, select Trunk and enter the trunk's directory
number.
2. Select DDI Line and set this to yes for DDI trunks.
3. For R2 DDI trunks select DDI digit count and enter the number of DDI digits
that should be passed through. Leave this field blank for non-R2 DDI trunks.
4. You may want to restrict the DDI trunk to incoming calls only, if so select Type
and set this to Incoming.
The INDeX routes DDI through ARS if the DDI digits match a string in ARS String
Analysis.
If the ARS processing goes to plan based analysis (see page 57), the Dialling
Plan number used is taken from the DDI trunk's associated Call Control Plan (see
page 41).
To set a trunk's dialling plan number :
1. From the Administration menu, select Call control plan and enter the
number of the trunk's associated call control plan.
2. Select Dialling plan and enter the required plan number.
DDI & Pilot Numbers
Programming Manual
INDeX 9.1
Advertisement
Table of Contents
