Panasonic KX-T336 System Reference Manual page 613

1.02 individual Trunk Group Dial
Access
Description
Allows the attendant to make outgoing CO calls
via an idle CO line in the specified trunk group by
dialing the feature number fpr "Trunk Group Ol-
08 Access" or "Trunk Group 09-l 6 Access."
TRG key (Programmable key) can be used for
this purpose instead of dialing the feature
number.
Refer to Section 6-C-l 0.00 "Attendant
Management Screen" for further information
about programmable key.
Programming
System Programming
Reference
VT 1 Dumb
I
"System-Numbering Plan (2/g)", 9-D-6.02 10-C-10.00
Trunk Group 01-08 Access
Truck Group 09- 16 Access
Conditions
i
If busy tone is heard, all CO lines in the specified
trunk group are in use.
Operation
Dial tone sounds:
(For instance, an idle LOOP key is pressed. SRC
indicator is lit and dial tone sounds.)
1. Press the TRG Key (Program-
mable key ), then dial the trunk
group number (01 to 16 ).
l
Another dial tone sounds. and
an idle line in specified trunk
group is selected automat&/y.
2. Dial the telephone number of tie
outside party.
(Supplement)
The following procedure substitutes operation for
step 1.
l
To select one of trunk groups 01 to 08:
Dial the feature number for "Trunk Group O? 48
Access," then dial the trunk group specifyiq
number (1 to 8).
In this case, dialed number matches trunk
group number as follows:
i Specify in; Number 1 Trunk Gr; Namber
l
To specify one of trunk groups 09 to 16: dial Ihe
feature number for "Trunk Group 09-l 6
Access" then dial the trunk group soecify'?C
number (1 to 8).
In this case dialed number matches trr;n%
group number as follows:
!
I
Specifying Number -1 Trunk Gross N~nSer
(Supplement)
For recalling after selecting a CO line. press Y-?
CANCEL key. After dial tone sounds. rec)cz: ~5
same procedure from
siep!
6-D-2