Sc0 Button - Panasonic KX-T336 System Reference Manual

3.05 SC0 Button
Description
To support prompt handling of outside calls, a CO
line can be assigned to a DN button on a PITS
telephone.
When this function is assigned, a DN button on a
PITS serves as the Single CO (SCO) button.
SC0 button feat_ure provides easy access to the
CO lines for extension users who make and
receive many outside calls.
The PITS telephone user can access a CO iine
by simply pressing the SC0 button without
dialing the CO line access code, and an incoming
outside call can be directed to the PITS
telephone via dedicated SC0 button without
assistance of the Operator.
In addition, the associated status LED provides
busy/idle status and the busy to idle reminder.
SC0 button can be used Qither one-way service
(Incoming Only or Outgoing Only) or two-ways
service (Both-Way).
SC0 button can be assigned to a PITS telephone
in conjunction with DIL 1:l or DIL 1 :N feature.
idle
I-use
Green 60 wink I-hold
Green 120 wink
I-exclusive hold, consultation hold.
unattended conference
Green 240 wink Incoming call (DIL 1:
1)
Lights red
Other-use, exclusive hold
Red 60 wink Other-hold
Red 120 wink Privacy release possible
Incoming call (DIL 1: N)
1 Red 240 wink
SC0 button with DIL
1: 1
feature
When DIL 1: 1 feature is employed, SC0 button
can be assigned to the PITS telephone
programmed as the destination of DIL
1: 1
feature.
If SC0 button is not assigned on the PITS
telephone, an incoming CO call arrives at a PDN
button on it.
j
The table below shows the relationship between
the DN button programmed as Single CO and the
CO line status:
CO Line Status
CO line which can be assigned as a SC0 button
is:
A CO line which belongs to a trunk group
assigned as Bothway or Incoming Only and
whose Incoming Mode (Day) is DIL 1: 1, or DIL
l:N.
A CO iine which belongs to a trunk group
assigned as Outgoing Only.
Programming
hi
Conditions
Even if Automatic Route Selection (ARS)
function is set, it is overridden by an outgoing
call made by pressing the Single CO button.
The Single CO button indicator will light up red
in the following circumstances.
cl
> When the Single CO is not. In Service
c2> idle status and Single CO in Busy Out
status
<3> idle status and Single CO in trunk route
control status
When the Single CO button is pressed in
any of these statuses, its indicator lights up
green but busy tone is heard.
In the following cases, the Single CO button
indicator remains lit green and reorder tone is
sent.
cl> When Calling Patty Control signal has
been detected during a call using the
Single CO.
c2> When outgoing restriction applies to an
outgoing call made from the Single CO.
4-B-9
(30393)