Cable Routing For The Power Module Board And Power Input Board Module - Lenovo ThinkEdge SE350 V2 User Manual

Cable routing for the power module board and power input board
module
Follow instructions in this section to learn how to do cable routing for the power input board (PIB) module
and power module board (PMB).
Attention:
• For a smooth installation, connect the cables between the power module board and power input board
module BEFORE installing the power module board.
Cable
LED connector on the power module
1
board
& Two connectors on the power module
2 3
board
Important:
• When connecting these power cables,
make sure to distinguish cables
and connect them correctly to their
3
respective connectors. Switching these
cables will cause failure.
Figure 128. Cable routing for the power input board module and power module board
of installing the PMB-PIB cables:
Procedure
Step 1. Make preparations for this task.
• Install the power input board module with LED cable (see
on page 120).
Step 2. Connect and organize the three cables (
module board.
a. Connect the PMB status LED cable (
b. Connect the power cables
connectors on the PMB.
Important:
ThinkEdge SE350 V2 User Guide
172
From
and
2
& &
1 2
) to the power module board.
1
and to the two connectors on the PIB module and the two
2 3
PMB status LED on the power input board module
Two connectors on the power input board module
"Install a power input board module"
) for the power input board module and power
3
To