Lenovo ThinkEdge SE350 V2 User Manual page 64

Figure 32. Installation of the enclosure into the rack by sliding
Procedure 2: by rotating and placing the enclosure down into the rails.
1. Place the enclosure down into the rails.
– Pull the rails forward until the inner rails click two times into place.
– Carefully lift the enclosure and tilt it into position over the rails so that the mounting studs
on the enclosure line up with the mounting holes of the inner rails.
– Slowly lower the enclosure down until the rear mounting studs slide into the rear
mounting holes; then, the front mounting studs go into the corresponding mounting holes of
the rails. Make sure that the mounting studs are locked into position so the enclosure is
firmly secured.
ThinkEdge SE350 V2 User Guide
56