Lenovo ThinkEdge SE350 V2 User Manual page 88

Demo video
https://www.youtube.com/watch?v=huDZmqU6pHQ
Remove the drive cage
Follow instructions in this section to remove the drive cage from the node.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read "Installation Guidelines" on page 37
you work safely.
• Remove the shipping bracket, if applicable (see
server and disconnect the power cords (see
• Remove the node from the enclosure , if applicable (see
lay the node on a flat, static-protective surface.
Note: Depending on the specific configuration, the drives, drive bay fillers, or drive cage might look different
from the illustrations in this section.
Procedure
Step 1. Make preparations for this task.
a. Remove all drives and drive bay fillers (see
disconnect all cables.
b. If applicable, unlock or remove any locking device that secures the top cover, such as a
Kensington lock; then, remove the top cover (see
c. Disconnect all the cables from the drive backplane(s) (see
drives" on page
Step 2. Disengage and remove the drive cage.
a. Remove the four screws as shown to disengage the drive cage.
ThinkEdge SE350 V2 User Guide
80
and "Safety inspection checklist" on page 38
"Configuration guide" on page
"Power off the server" on page
165).
44).
"Configuration guide" on page
"Remove a hot-swap drive" on page
"Remove the top cover" on page
"Cable routing for the hot-swap
to make sure that
45); then, power off the
45); then, carefully
78) and
158).