Lenovo ThinkEdge SE350 V2 User Manual page 175

• For a better result of cable routing, install the cable of the keylock switch before connecting the drive-
backplane power cable (
7mm SATA drives
Figure 124. Backplane power cable and SATA cable for the 7mm drives; Drive backplane 1 (lower)
Cable
Drive-backplane 1 power connector
1
Drive-backplane 1 MCIOx4 connector for SATA
2
Attention:
• Make sure that all cables between the drive backplane(s) and the system-board connectors go through
the cable wall on the power module board.
) (see "Install a keylock switch with cable" on page
1
From
102).
Power connector for drive backplane on the I/O module
board
SATA connector on the system board
Chapter 6
To
.
Internal cable routing
167