Lenovo ThinkEdge SE350 V2 User Manual page 139

CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read "Installation Guidelines" on page 37
you work safely.
• Remove the shipping bracket, if applicable (see
server and disconnect the power cords (see
• Lay the node on a flat, static-protective surface.
Procedure
Step 1. Carefully place the node or node sleeve upside down.
Step 2. Remove a rubber pad by pulling it from the node or node sleeve.
Figure 96. Removal of a rubber pad
Step 3. (Optional) If necessary, repeat the same step for the other three rubber feet.
After this task is completed
• If necessary, install a replacement unit (see
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
and "Safety inspection checklist" on page 38
"Configuration guide" on page
"Power off the server" on page
"Install the rubber feet" on page
Chapter 5
to make sure that
45); then, power off the
44).
132).
.
Hardware replacement procedures
131