Lenovo ThinkEdge SE350 V2 User Manual page 99

• Read "Installation Guidelines" on page 37
you work safely.
• Remove the shipping bracket, if applicable (see
server and disconnect the power cords (see
• Remove the node from the enclosure , if applicable (see
lay the node on a flat, static-protective surface.
Procedure
Step 1. Make preparations for this task.
a. If applicable, unlock or remove any locking device that secures the top cover, such as a
Kensington lock; then, remove the top cover (see
b. Remove the air baffle (see
c. If necessary, remove the intrusion switch (see
96).
Step 2. Remove the fan module.
a. Disconnect the fan cable from the connector on the system board.
b. Locate the hole under the fan slot; then, disengage the fan module by pushing it through this
hole from the underside of the node.
c. Lift the fan module up to remove it from the node.
Figure 64. Disconnection of a fan cable and removal of a fan module
After this task is completed
• Install a replacement fan (see
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
and "Safety inspection checklist" on page 38
"Configuration guide" on page
"Power off the server" on page
"Remove the air baffle" on page
"Install a fan module" on page
45); then, power off the
44).
"Configuration guide" on page
"Remove the top cover" on page
68).
"Remove the keylock switch with cable" on page
92).
.
Chapter 5 Hardware replacement procedures
to make sure that
45); then, carefully
158).
91