Lenovo ThinkEdge SE350 V2 User Manual page 145

Figure 100. Removal of the screws from the I/O module board
Step 3. Slightly pivot the I/O module board at an angle to disengage it; then, pull the I/O module board
toward the front of the node to remove it.
Attention: When disengaging and removing the I/O module board, make sure to:
• pivot the I/O module board at a small angle to avoid interfering with the studs on the chassis
sidewalls; and
• keep the I/O module board under these studs.
Figure 101. Removal of the I/O module board
After this task is completed
• Install a replacement unit (see
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
• If any M.2 boot drives are installed on the I/O module board, remove them before returning or recycling
the I/O module board (see
"Install an I/O module board" on page
"Remove an M.2 boot drive" on page
150).
104).
.
Chapter 5 Hardware replacement procedures
137