Figure 37. Installation of the shipping bracket screws
After this task is completed
• Proceed to complete the parts replacement (see
Dust filter replacement
Follow instructions in this section to remove or install a dust filter. The server might or might not come with
this component.
Important:
• Depending on the environment, check the status of the dust filter at least every 3 months to make sure it is
functional.
• It is recommended to have a dust filter installed when the server is in operation.
Remove the dust filter
Follow instructions in this section to remove the dust filter from the shipping bracket of an enclosure or the
security bezel of a node sleeve.
About this task
Attention:
• Read
"Installation Guidelines" on page 37
you work safely.
Important:
• Depending on the environment, check the status of the dust filter at least every 3 months to make sure it is
functional.
• It is recommended to have a dust filter installed when the server is in operation.
Remove the dust filter from the shipping bracket of an enclosure
Notes:
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 38
Chapter 5
161).
to make sure that
.
Hardware replacement procedures
59