Step 2.
Remove Drive backplane 2 (upper).
a.
Remove the 3 screws that secure Drive-backplane 2.
b.
Disengage and remove Drive-backplane 2.
Figure 57. Removal of Drive backplane 2 (upper)
Step 3.
Remove Drive backplane 1 (lower) from the drive cage.
a.
Remove the two hex standoffs that secure Drive-backplane 1.
b.
Disengage and remove Drive-backplane 1.
Figure 58. Removal of the Drive backplane 1 (lower)
Note: The hex standoffs are designed to be used with a common Phillips screwdriver or flat-
head screwdriver.
After this task is completed
• Install a replacement unit (see
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
"Install a drive backplane" on page
84).
.
Chapter 5
Hardware replacement procedures
83