Figure 74. Installation of the keylock switch with cable onto the bracket
Step 2.
Install the keylock switch with cable to the node.
a.
Hook the keylock switch onto the pin on the sidewall of the node; then, slightly push it
leftward.
b.
Tighten the screw to secure the keylock switch.
c.
Connect the keylock switch cable to the system board.
Figure 75. Installation of a keylock switch with cable
After this task is completed
• Reconnect the drive-backplane power cable to the I/O module board (see
drives" on page
165).
• Proceed to complete the parts replacement (see
Demo video
"Complete the parts replacement" on page
.
Chapter 5
Hardware replacement procedures
"Cable routing for the hot-swap
161).
103