Install A Dust Filter - Lenovo ThinkEdge SE350 V2 User Manual

• Depending on the specific configuration, the node, enclosure, or rails might look different from the
illustrations in this section.
• For details of the rail options for the rack installation, see
Procedure
Step 1. Make preparations for this task.
a. Remove the shipping bracket from the enclosure (see
45).
Step 2. Remove the dust filter from the shipping bracket.
Figure 38. Removal of the dust filter from the shipping bracket
After this task is completed
• Install a replacement unit (see
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.

Install a dust filter

Follow instructions in this section to install a dust filter into the shipping bracket of an enclosure or the
security bezel of a node sleeve.
About this task
Attention:
• Read "Installation Guidelines" on page 37
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node; then, remove it from the package and place it on a static-protective surface.
Important:
• Depending on the environment, check the status of the dust filter at least every 3 months to make sure it is
functional.
• It is recommended to have a dust filter installed when the server is in operation.
ThinkEdge SE350 V2 User Guide
60
"Install a dust filter" on page
and "Safety inspection checklist" on page 38
" Rail Installation Guides" on page
"Remove a node from a rack" on page
60).
215.
to make sure that