Lenovo ThinkEdge SE350 V2 User Manual page 170

2. Properly route and secure the cables in the node. Refer to the cable connecting and routing information
for each component (see
3. If applicable, reinstall the air baffle (see
4. If applicable, install the top cover onto the node (see
5. If necessary, reinstall the node back into an enclosure (see
6. If necessary, install any locking devices that secure the top cover, such as a Kensington lock.
7. After checking and making sure that all necessary items are in place, reconnect all external cables and
then the power cords to the server.
Attention: To avoid component damage, connect all the other cables before connecting the power
cords.
8. Power on the server (see
9. If necessary, reinstall the shipping bracket back into place (see
10. Update the server configuration.
• Download and install the latest device drivers:
• Update the system firmware (see
• Update the UEFI configuration. See
• Reconfigure the disk arrays if you have installed or removed a hot-swap drive. See
pubs.lenovo.com/lxpm-overview/
ThinkEdge SE350 V2 User Guide
162
Chapter 6 "Internal cable routing" on page
"Install an air baffle" on page
"Power on the server" on page
"Update the firmware" on page
https://pubs.lenovo.com/uefi-overview/
for the LXPM documentation compatible with your server.
163).
70).
"Install the top cover" on page
"Configuration guide" on page
43).
"Configuration guide" on page
http://datacentersupport.lenovo.com
177).
160).
45).
45).
.
.
https://