Yamaha XSR 900 2022 Service Manual page 67

1. Brake fluid reservoir hose
2. Rear brake light switch lead
3. Rear brake hose (rear brake master cylinder
to hydraulic unit)
4. Rear wheel sensor
5. Rear wheel sensor lead
6. Rear brake hose (hydraulic unit to rear brake
caliper)
7. Rear fender
8. Swingarm
9. Bracket
A. Align the white paint mark on the rear brake
hose (hydraulic unit to rear brake caliper) and
white tape on the rear wheel sensor lead, and
then fasten the rear wheel sensor lead and
rear brake hose (hydraulic unit to rear brake
caliper) with the clamp.
B. Align the white tape on the rear wheel sensor
lead, and then fasten the rear wheel sensor
lead and rear brake hose (hydraulic unit to
rear brake caliper) with the clamp.
C. Fasten the rear brake hose with the clamp at
the hose protector on the rear brake hose.
D. Route the rear wheel sensor leads between
the clamps along the outside of the rear
brake hose (hydraulic unit to rear brake cali-
per).
E. Face the catch of the clamp upward.
F. Route the rear wheel sensor lead on the out-
side of the rear brake hose (hydraulic unit to
rear brake caliper).
G. Route the rear wheel sensor lead and rear
brake hose (hydraulic unit to rear brake cali-
per) through the guide.
H. Fasten the grommet on the rear wheel sensor
lead with the bracket.
I. Align the gray tape on the rear brake light
switch lead, and then fasten the rear brake
light switch lead and rear brake hose (rear
brake master cylinder to hydraulic unit) with
the clamp.
J. 70 mm (2.76 in)
K. Route the rear brake light switch lead on the
forward of the rear brake hose (rear brake
master cylinder to hydraulic unit).
L. Forward of the vehicle
M. The opening of the clamp should face the
rear. Make sure the clamp is engaged by 3 or
more notches.
N. Route the rear wheel sensor lead on the out-
side of the rear brake hose (hydraulic unit to
rear brake caliper).
O. 45°
P. Outward
Q. Route the rear wheel sensor lead along the
rear brake hose (hydraulic unit to rear brake
caliper). Position the rear wheel sensor lead
within the range shown in the illustration.
R. Fasten the grommet of the rear wheel sensor
lead with the clamp. Route the rear wheel
sensor lead on the outside of the rear brake
hose (hydraulic unit to rear brake caliper).
S. The opening of the clamp should face the
outside. Make sure the clamp is engaged by
3 or more notches.
T. The opening of the clamp should face the
inside.
2-38
CABLE ROUTING