Yamaha XSR 900 2022 Service Manual page 271

Clutch boss nut
125 N·m (12.5 kgf·m, 92 lb·ft)
TIP
• Install the conical spring washer on the main
axle with the "OUT" mark "a" facing away from
the vehicle.
• While holding the clutch boss "1" with the uni-
versal clutch holder "4", tighten the clutch boss
nut.
• Stake the clutch boss nut at cutouts "b" in the
main axle.
Clutch holder
90890-04199
Universal clutch holder
YM-91042
4
b
3. Install:
• Clutch damper spring seat
• Clutch damper spring
• Friction plate 2
• Clutch plate 2
• Friction plate 1
• Clutch plate 1
TIP
• First, install a friction plate and then alternate
• Install the last friction plate "1" offset from the
4. Install:
3 New
1
2
a
TIP
• Tighten the clutch spring bolts in stages and in
• Apply lithium-soap-based grease onto the pull
• Position the pull rod so that the teeth "a" face
5-54
between a clutch plate and a friction plate.
other friction plates "2", making sure to align a
projection on the friction plate with the punch
mark "a" on the clutch housing.
2
a
1
• Pull rod
• Pressure plate 2
• Clutch spring
• Pressure plate 1
• Clutch spring bolt "1"
Clutch spring bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
• Oil pump driven sprocket "2"
Oil pump driven sprocket bolt
15 N·m (1.5 kgf·m, 11 lb·ft)
LOCTITE®
a crisscross pattern.
rod.
towards the hole "b". Then, install the clutch
cover.
1
CLUTCH
1