Assembling The Main Axle And Drive Axle - Yamaha XSR 900 2022 Service Manual

EAS30435
ASSEMBLING THE MAIN AXLE AND DRIVE
AXLE
1. Install:
• Toothed washer "1"
• Circlip "2"
New
TIP
• Be sure the circlip sharp-edged corner "a" is
positioned opposite side to the toothed washer
and gear.
• Align the opening between the ends "b" of the
circlip with a groove "c" in the axle.
• Install the circlip so that a spline "d" is in the
center of the gap between the circlip ends "e"
as shown.
A. Main axle
B. Drive axle
b
c
e
d
2. Install:
• Toothed lock washer retainer "1"
• Toothed lock washer "2"
TIP
• With the toothed lock washer retainer in the
groove "a" in the axle, align the projection on
the retainer with an axle spline, and then install
the toothed lock washer.
• Be sure to align the projection on the toothed
lock washer that is between the alignment
marks "b" with the alignment mark "c" on the re-
tainer.
A
2
1
a
B
2
1
a
A. Main axle
B. Drive axle
5-94
TRANSMISSION
1
c
1
b
2
b
2