EAS20416
P0915
EAS32836
TROUBLESHOOTING
Item
Gear position sensor: out of control signal range and normal signal is not received from the gear posi-
tion sensor to ECU.
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
TIP
If more than one DTC is detected at the same time, perform troubleshooting of DTC listed below first.
• P0916, P0917
1. Installed condition of gear position sensor.
• Check for looseness or pinching.
Refer to "CRANKCASE" on page 5-64.
Is check result OK?
YES
→ Go to step 2.
NO
a. Reinstall or replace the sensor.
Refer to "CRANKCASE" on page 5-64.
b. Make sure that the position of each gear is correctly displayed on the meter.
Is check result OK?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 2.
2. Connection of gear position sensor coupler.
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
Is the coupler condition normal?
YES
→ Go to step 3.
NO
a. Connect the coupler securely or replace the wire harness.
b. Make sure that the position of each gear is correctly displayed on the meter.
Is check result OK?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 3.
9-216
P0915