Yamaha XSR 900 2022 Service Manual page 15

The function of the wheel switch can be locked
into grip warmer mode by pressing and holding
the wheel switch inward while the grip warmer
indicator is highlighted by the cursor.
In this mode, the temperature levels can be in-
stantly adjusted by rotating the wheel switch up/
down.
To exit this mode and return the wheel switch to
its normal functionality, press and hold the wheel
switch inward.
TIP
The current grip warmer setting is saved when
the vehicle is turned off.
Lap timer
This stopwatch function can be activated
through the setting MENU.
Once activated, the vehicle information display
is replaced with:
1
1. Lap count
2. Current lap time
3. Latest/Previous lap time
To start the timer, push the dimmer/pass switch
down towards "PASS".
Each push of the dimmer/pass switch will in-
crease the lap count by 1 and reset the current
lap timer.
To pause the lap timer, press the wheel switch
inward.
To unpause the timer, push the dimmer/pass
switch down towards "PASS" and the timer will
resume without counting a new lap.
To exit the lap time mode, turn it off in the set-
tings MENU.
TIP
• The engine must be running to start the lap tim-
er.
• The headlight will flash when the dimmer/pass
switch is pressed.
• Whenever the lap timer is paused, it can be re-
sumed using the dimmer/pass switch.
2
0 0 : 1 2 . 3 4
02
LAP
3
0 0 : 3 0 . 2 3
LATEST
Brake control icon "BC"
This icon is replaced by the auxiliary system
warning and coolant temperature warning indi-
cators when they are activated.
Error mode warning "Err"
When an internal error occurs (e.g., communica-
tion with a system controller has been cut off),
the error mode warning will appear as follows.
"Err" and " " indicator light indicates an ECU
error.
"Err" only indicates an ABS ECU error.
TIP
Depending on the nature of the error, the display
may not function properly and the traction con-
trol system settings may be impossible to
change. Additionally, ABS may not function
properly. Use extra care when braking and have
a Yamaha dealer check the vehicle immediately.
Auxiliary system warning "
This icon appears if a problem is detected in a
non-engine-related system.
Coolant temperature warning "
This icon appears if the coolant temperature
reaches 116 °C (241 °F) or higher. Stop the ve-
hicle and turn off the engine. Allow the engine to
cool.
ECA10022
NOTICE
Do not continue to operate the engine if it is
overheating.
Oil pressure warning "
This icon appears when the engine oil pressure
is low. When the vehicle is first turned on, engine
oil pressure has yet to build, so this icon will
come on and stay on until the engine has been
started.
TIP
If a malfunction is detected, the oil pressure
warning icon will flash repeatedly.
ECA27240
NOTICE
Do not continue to operate the engine if the
oil pressure is low.
1-6
FEATURES
"
"
"