A
1
L G/W B/L
Is resistance ∞ Ω?
YES
→ Go to step 4.
NO
a. Replace the wire harness.
b. Turn the main switch to "ON", and then check the DTC using the malfunction mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 4.
4. Installed condition of gear position sensor.
• Check for looseness or pinching.
Refer to "CRANKCASE" on page 5-64.
Is check result OK?
YES
→ Go to step 5.
NO
a. Reinstall or replace the sensor.
b. Turn the main switch to "ON", and then check the DTC using the malfunction mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 5.
5. Defective gear position sensor.
• Make sure that the position of each gear is correctly displayed on the meter.
Is check result OK?
YES
→ Go to step 6.
NO
a. Replace the gear position sensor.
Refer to "CRANKCASE" on page 5-64.
b. Turn the main switch to "ON", and then check the DTC using the malfunction mode of the YDT.
B
1
2
L G/W B/L
9-220
P0916, P0917
L/B
Y/L
O/W
Lg/L
P/W
P
V
L
L
L/W
B/Y
Br/L
G/L
Gy/G
Br/W
B/L
B/L
L/Y
L/W
Lg/B
G/W
G/W
Gy
W/G
W/Y