Yamaha XSR 900 2022 Service Manual page 59

1. Crankshaft position sensor lead
2. Crankshaft position sensor coupler
3. Rear brake light switch lead
4. Wire harness (to rectifier/regulator)
5. Rear wheel sensor lead
6. Rear wheel sensor coupler
7. Wire harness (to joint coupler)
8. Wire harness (to ABS)
9. Radiator fan motor relay
10. Battery box
11. Fuse box
12. Positive battery lead
13. Starter relay
14. Bracket
15. Starter motor lead
16. Wire harness (to battery negative terminal)
17. IMU (Inertial Measurement Unit)
18. IMU coupler
19. Wire harness (to radiator fan motor relay)
20. Wire harness
21. Clamp
22. Negative battery lead
A. Forward of vehicle
B. Pass the crankshaft position sensor lead
beneath the wire harness (to stator coil
assembly) and connect the crankshaft posi-
tion sensor coupler on the right side of the
vehicle.
C. Route the rear brake light switch lead on the
rear side of the wire harness (to rectifier/reg-
ulator).
D. Route the rear wheel sensor lead on the rear
side of the wire harness (to rectifier/regula-
tor).
E. Insert the starter relay until it stops the rib
stopper on the battery box.
F. Pass the starter motor lead under the
bracket.
G. Route the wire harness (to radiator fan motor
relay) on the rear side of the wire harness (to
ABS ECU) and wire harness (to joint cou-
pler).
H. Route the rear brake light switch lead on the
top side of the wire harness.
I. Pass the wire harness (to radiator fan motor
relay) to the forward of the vehicle on the
clamp.
J. Top of the vehicle
K. Route the wire harness (to radiator fan motor
relay) over the starter motor lead.
L. Insert the projection on the wire harness
clamp into the hole in the battery box.
M. Pass the starter motor lead under the wire
harness.
2-30
CABLE ROUTING