Yamaha XSR 900 2022 Service Manual page 185

3
c
d. Install the rearview mirror (right) "5".
TIP
When installing the rearview mirror, align the
mark "f" on the rearview mirror with the between
lines mark "g" on the handlebar, as shown in the
figure.
5. Install:
• Front brake master cylinder assembly
Refer to "INSTALLING THE FRONT BRAKE
MASTER CYLINDER" on page 4-37.
6. Install:
• Clutch lever holder "1"
• Clutch cable
Clutch lever holder pinch bolt
11 N·m (1.1 kgf·m, 8.1 lb·ft)
TIP
Align the center of slit on the clutch lever holder
with the punch mark "a" on the handlebar.
d
4
e
5
f
g
7. Install:
• Handlebar grip
• Rearview mirror (left)
Rearview mirror bolt (left)
38 N·m (3.8 kgf·m, 28 lb·ft)
a. Apply a thin coat of rubber adhesive onto
the end of the handlebar (left).
b. Slide the handlebar grip over the end of the
handlebar (left).
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 4–6 mm (0.16–0.24 in) of clear-
ance "a" between the handlebar grip and the
handlebar end.
a
4-64
HANDLEBAR
1
a