P00D1, P2195; Troubleshooting - Yamaha XSR 900 2022 Service Manual

Hide thumbs Also See for XSR 900 2022:
Table of Contents

Advertisement

EAS20660

P00D1, P2195

EAS33115

TROUBLESHOOTING

Item
• [P00D1] O
sensor: heater performance is deteriorated. Normal signal is not received from the O
2
sor while driving the O
• [P2195] O
sensor: open circuit is detected. Normal signal is not received from the O
2
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
TIP
If more than one DTC is detected at the same time, perform troubleshooting of DTC listed below first.
• P0030
1. Installed condition of O
• Check for looseness or pinching.
Is check result OK?
YES
→ Go to step 2.
NO
a. Reinstall or replace the O
Refer to "ENGINE REMOVAL" on page 5-9.
b. Start the engine and let it idle for approximately 1 minute.
c. Check the DTC using the malfunction mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 8, and complete the service.
NO
→ Go to step 2.
2. Connection of O
sensor coupler.
2
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
Is the coupler condition normal?
YES
→ Go to step 3.
NO
a. Connect the coupler securely or replace the wire harness.
b. Start the engine and let it idle for approximately 1 minute.
c. Check the DTC using the malfunction mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 8, and complete the service.
NO
→ Go to step 3.
sensor heater.
2
sensor.
2
sensor.
2
9-98
P00D1, P2195
sen-
2
sensor.
2

Advertisement

Table of Contents
loading

Table of Contents