Yamaha XSR 900 2022 Service Manual page 17

Traction control system
This model uses a variable traction control sys-
tem. For each setting level, the further the vehi-
cle is leaned over, the greater the amount of
traction control (system intervention) is applied.
There are 3 setting levels available for the "TCS-
MODE M".
Setting level 1 applies the least amount of over-
all system intervention, while setting level 3 ap-
plies the greatest amount of overall traction
control.
TIP
• The traction control system can only be turned
on or off via the main screen using the MODE
switches.
• SCS and LIF can be turned off independently
of traction control system for "TCS-MODE M".
• When "TCS-MODE" has been set to "OFF" on
the main screen: traction control system, SCS
and LIF are all turned off together.
SCS
SCS can be set to OFF, 1, 2, and 3.
OFF turns the slide control system off, setting
level 1 provides the least amount of system in-
tervention, and setting level 3 provides the
greatest amount of system intervention.
LIF
LIF can be set to OFF, 1, 2, and 3.
Setting level 1 provides the least amount of sys-
tem intervention and setting 3 most strongly re-
duces the rate of wheel lift.
OFF turns LIF off.
"Vehicle Setting"
Vehicle Setting
BC Setting
QS Setting
The vehicle setting module allows you to adjust
setting for the BC and quick shifter.
km/h
1-8
BC
BC Setting
BC
The brake control system has two settings, BC1
and BC2. Select BC1 when only standard ABS
is desired. Select BC2 to have the brake control
system further regulate brake pressure while
cornering to suppress lateral wheel slip.
TIP
For skilled riders and when riding at the track,
due to varying conditions, the BC2 brake system
may engage sooner than expected relative to
your desired cornering speed or intended cor-
nering line.
Quick shifter
QS Setting
QS
QS
The quick shifter indicators are divided into
QS and QS sections.
QS and QS are not linked and can be inde-
pendently turned on or off.
The quick shifter can be set to ON or OFF.
OFF turns the respective upshift or downshift
function off, and the clutch lever must then be
used when shifting in that direction.
TIP
If the quick shifter setting cannot be changed:
turn the engine off with the gear position set to
neutral, then change the setting.
FEATURES
2
km/h
ON
ON
km/h