Yamaha XSR 900 2022 Service Manual page 108

TIP
The spring preload setting is determined by
measuring the distance "c" shown in the illustra-
tion. The shorter distance "c" is, the higher the
spring preload; the longer distance "c" is, the
lower the spring preload.
c
Spring preload
Adjustment value (Soft)
19.0 mm (0.75 in)
Adjustment value (STD)
14.0 mm (0.55 in)
Adjustment value (Hard)
4.0 mm (0.16 in)
Rebound damping (right side only)
ECA13590
NOTICE
Never go beyond the maximum or minimum
adjustment positions.
1. Adjust:
• Rebound damping
a. Turn the adjusting screw "1" in direction "a"
or "b".
Direction "a"
Rebound damping is increased (sus-
pension is harder).
Direction "b"
Rebound damping is decreased (sus-
pension is softer).
PERIODIC MAINTENANCE
Rebound damping
Adjustment value from the start
position (Soft)
11
Adjustment value from the start
position (STD)
6
Adjustment value from the start
position (Hard)
1
* Start position: With the adjusting screw
fully turned in direction "a"
TIP
• Although the total number of clicks of a damp-
ing force adjusting mechanism may not exactly
match the above specifications due to small
differences in production, the actual number of
clicks always represents the entire adjusting
range. To obtain a precise adjustment, it would
be advisable to check the number of clicks of
each damping force adjusting mechanism and
to modify the specifications as necessary.
• When turning the damping force adjusting bolt
in direction "a", the 0 click position and the 1
click position may be the same.
Compression damping (left side only)
ECA13590
NOTICE
Never go beyond the maximum or minimum
adjustment positions.
1. Adjust:
• Compression damping
3-22
1
a b