EAS20417
P0914
EAS32837
TROUBLESHOOTING
Item
Gear position sensor: signal stuck and sensor signal does not change.
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
TIP
• If more than one DTC is detected at the same time, perform troubleshooting of DTC listed below first.
• P0335, P0500, P0915, P0916, P0917, P1500
1. Installed condition of gear position sensor.
• Check for looseness or pinching.
Refer to "CRANKCASE" on page 5-64.
Is check result OK?
YES
→ Go to step 2.
NO
a. Reinstall or replace the sensor.
Refer to "CRANKCASE" on page 5-64.
b. Make sure that the position of each gear is correctly displayed on the meter.
Is check result OK?
YES
→ Go to step 4, and complete the service.
NO
→ Go to step 2.
2. Defective gear position sensor.
• Disconnect the ECU coupler "1".
• Measure the gear position sensor resistance.
ECU coupler "1"
• Shift the transmission to each position.
green/white–black/blue
1
L/B
Y/L
O/W
Lg/L
P/W
P
V
L
L/W
B/Y
Br/L
G/L
Gy/G
Br/W
B/L
L/Y
L/W
Lg/B
G/W
G/W
9-214
L
Gy
B/L
W/G
W/Y
P0914