Yamaha XSR 900 2022 Service Manual page 297

Hide thumbs Also See for XSR 900 2022:

Table of Contents

If the bolt is tightened more than the speci-

fied angle, do not loosen the bolt and then re-

tighten it. Instead, replace the bolt with a new

one and perform the procedure again.

Do not use a torque wrench to tighten the

bolt to the specified angle.

d. After the installation, check that the section

shown "a" is flush with each other by touch-

ing the surface.

If the connecting rod and cap are not flush

with each other, remove the connecting rod

bolts and big end bearing and restart from

step (1). In this case, make sure to replace

the connecting rod bolts.

CONNECTING RODS AND PISTONS

Chapters

Table of Contents