Yamaha XSR 900 2022 Service Manual page 467

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
DTC Item
P0335 Crankshaft position
sensor: normal sig-
nals are not re-
ceived from the
crankshaft position
sensor.
P0351 [P0351] Cylinder-#1
P0352 ignition coil: open or
P0353 short circuit is de-
tected in the primary
lead of the cylinder-
#1 ignition coil. Nor-
mal signal is not re-
ceived from the
ignition circuit.
[P0352] Cylinder-#2
ignition coil: open or
short circuit is de-
tected in the primary
lead of the cylinder-
#2 ignition coil. Nor-
mal signal is not re-
ceived from the
ignition circuit.
[P0353] Cylinder-#3
ignition coil: open or
short circuit is de-
tected in the primary
lead of the cylinder-
#3 ignition coil. Nor-
mal signal is not re-
ceived from the
ignition circuit.
P0458 Purge cut valve so-
lenoid: open circuit
is detected. PCV so-
lenoid is not operat-
ed.
Probable cause of
malfunction
• Defective coupler
between crank-
shaft position sen-
sor and ECU.
• Open or short cir-
cuit in wire har-
ness between
crankshaft position
sensor and ECU.
• Improperly in-
stalled crankshaft
position sensor.
• Malfunction in
generator rotor.
• Defective crank-
shaft position sen-
sor.
• Malfunction in
ECU.
• Defective coupler
between ignition
coil and ECU.
• Open or short cir-
cuit in wire har-
ness between
ignition coil and
ECU.
• Improperly in-
stalled ignition coil.
• Defective ignition
coil.
• Malfunction in
ECU.
• Open or short cir-
cuit in wire har-
ness.
• Defective purge
cut valve solenoid.
• Malfunction in
ECU.
9-61
Vehicle symptom
Engine cannot be
started.
Engine stops.
Loss of engine pow-
er.
Engine is difficult to
start.
Engine cannot be
started.
Engine idling speed
is unstable.
Increased exhaust
emissions.
Vapor gas cannot
be purged from can-
ister.
Fail-safe system
operation
Does not operate.
ISC feedback is not
carried out.
ISC learning is not
carried out.
Cruise control fixed
to OFF.
O feedback is not
2
carried out.
ISC feedback is not
carried out.
ISC learning is not
carried out.
Quick shift system is
not carried out.
Cruise control fixed
to OFF.
Closing side on
purge cut valve so-
lenoid is fixed.