Table of Contents
Advertisement
40
4.7
Changing the bobbin
WARNING
Risk of injury from needle tip and moving parts!
Puncture, cutting and crushing possible.
Turn off the machine before changing the bobbin.
The procedure used to change the bobbin is the same for 1-needle
machines and 2-needle machines. The only difference is that the
hook into which the bobbin is inserted is turned by 180 degrees
for the left and the right side.
Fig. 19: Changing the bobbin
①
(1) - Slot
(2) - Guide
(3) - Tension spring
To change the bobbin:
1.
Swivel up the bobbin case retainer (6).
2.
Remove the empty bobbin.
3.
Insert a full bobbin:
Important
Insert the bobbin so that it moves in the opposite direction of the
hook when the thread is pulled out.
4.
Feed the hook thread through the slot (4) in the bobbin case
retainer.
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
⑥
② ③ ④
(4) - Slot
(5) - Bobbin
(6) - Bobbin case retainer
Operation
⑤
Advertisement
Table of Contents
