Duerkopp Adler 869-M PREMIUM Operating Instructions Manual page 64

62
Symbol Meaning
Other parameters
• Use the OK button to go to the list
• Use ▲/▼ to select the parameter
• Use the OK button to go to the parameter settings
More detailed description of parameters:
• Speed (Max Speed) ( p. 67)
• Thread cutter (Thread Trim) ( p. 67)
• Thread clamp (Thread Clamp) ( p. 68)
• Initial alignment stitch (PointPos.°) ( p. 68)
• Start bartack (Start Tack) ( p. 68)
• End bartack (End Tack) ( p. 72)
• Sewing foot lift (Foot) ( p. 74)
• Bobbin monitor (Bobbin) ( p. 75)
• Information (InfoScreen) ( p. 77)
• Puller (Puller) ( p. 78)
• Edge stop (EdgeGuide) ( p. 78)
• Correcting effects of high speed
(Speed Corr) ( p. 79)
• Material thickness detection (Mat.Thickness) ( p. 83)
• Light barrier (LightBarrier) ( p. 88)
• Outputs (Output) ( p. 89)
S.p.m. or seam length in [mm]
The active option, either s.p.m. or mm, can be set at the
Technician level. The s.p.m. option is set at the factory.
After the thread has been cut off, the display is retained.
Measurement/counting restarts when sewing starts again.
• Cancel the function
• Exit the menu (changes remain saved) to return to the
starting level
• Confirm the settings
• Activate the input
Create a program,  p. 94.
No function assigned
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
Programming