Table of Contents
Advertisement
Step 1.
Use the key to unlock the server cover; then, open the front door.
Step 2.
Locate the simple-swap drive you want to remove.
Step 3.
Remove the simple-swap drive.
Figure 49. Opening the tray handle of a 3.5-inch simple-swap drive
a.
Use a screwdriver to turn the handle lock to the unlocked position.
b.
The tray handle opens automatically.
c.
Pull the tray handle and carefully slide the simple-swap drive out of the drive bay.
After you finish
1. Install a new drive or drive filler into the vacant drive bay. See "Install a simple-swap drive" on page 81.
Note: To ensure that there is adequate system cooling, do not operate the server for more than two
minutes without either a drive or a drive filler installed in each bay.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a simple-swap drive
Use this information to install a simple-swap drive.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
.
Chapter 4
Hardware replacement procedures
81
Advertisement
Table of Contents
