Adjusting The Anti-Scalp Rollers - Toro 30486 Operator's Manual

Figure 14
1. Carrier Frame
2. Hairpin Cotter
3. Back height-of-cut post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in the proper
hole location for each height-of-cut position. There
needs to be 3/8 inch (10 mm) minimum clearance
above the ground.
Note: If the anti-scalp rollers are adjusted too low it
can cause excess wear of the rollers.
1. After adjusting height-of-cut, check the anti-scalp
rollers so that there is a minimum of 3/8 inch
(10 mm) clearance above the ground (Figure 15,
Figure 16, Figure 17).
2. If adjustment is needed, remove the bolt, washers
and nut (Figure 15, Figure 16, Figure 17).
3. Select a hole position so the anti-scalp rollers are
a minimum of 3/8 inch (10 mm) off the ground
(Figure 15, Figure 16, Figure 17).
4. Install the bolt and nut (Figure 15, Figure 16,
Figure 17).
4. Spacers
5. Front height-of-cut post
40 inch, 48 inch, and 52 inch Mower Decks
1. Mower deck
2. Bolt
3. Spacer
40 inch, 48 inch, and 52 inch Mower Decks
1. Mower deck
2. Bolt
3. Spacer
20
Figure 15
4. Anti-Scalp Rollers
5. Nut
Figure 16
4. Bushing
5. Anti-Scalp Rollers
6. Nut