Setup; Installing The Blade Control Bar; Installing The Handle; Filling The Engine With Oil - Toro Recycler 20958 Operator's Manual

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Installing the Blade Control
Bar
No Parts Required
Procedure
Install the blade-control bar into the upper handle (Figure 3).
2

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(Figure 4).
Figure 3
Important: Route the cables to the outside of the
handle knobs as you install the handle.
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1.
3

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
crankcase with oil.
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 5) and pour about 3/4 of
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 0.59 l (20 fl. oz.), type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.
5
Figure 4