Hardware & Lan Problems - SMC Networks EZ Networking SMC2621W-P User Manual

This chapter describes some critical situations, which may arise,
and the solutions to them.
Overview
If you encounter printing difficulties, please refer to the appropriate
section. If, after following the advice in these documents, the
Wireless Print Server still does not function properly, please
contact your dealer for further advice.
Hardware & LAN Problems
Problem No. 1
Solution No. 1
Problem No. 2
Solution No. 2
Problem No. 3
Solution No. 3
T
ROUBLESHOOTING
All the Wireless Print Server's LEDs are off.
Check the power supply or power connection.
Wireless Print Server's RED status LED
continuously stays on.
Reset the Wireless Print Server by unplugging the
power supply and plugging it back in.
The Wireless Print Server unit can not be found
on the LAN, so configuration is not possible.
If using 10/100BaseT:
•
Check the Hub. The link LED for the port to which the
Wireless Print Server is connected should be ON.
If it is Off, there is a problem in the network cable.
C
HAPTER
8
95