SMC Networks EZ Networking SMC2621W-P User Manual page 19

Chapter 3 Wireless Print Server Configuration
6. Click [Next] to configure the [TCP/IP] Screen.
•
•
7. On the Wireless Screens, the settings should be set to match
your other Wireless Stations. For details about each setting,
refer to the following section Wireless Configuration.
8. Click [Finish] to save the data to the Wireless Print Server.
Note:
If the desired Wireless Print Server is not listed:
•
Check all cables to the Wireless Print Server.
•
Check the Wireless Print Server's LEDs:
•
•
•
Check that your PC and the Wireless Print Server are on the
same LAN segment. (If you don't have a Router or Gateway
on your LAN, you only have 1 segment.)
•
Check that your PC has either the TCP/IP or NetBEUI network
protocols installed. See Checking your Network Protocols
(Windows 9x) in Chapter 4 for details.
Note:
14
Select [Obtain IP Address automatically] if your LAN
has a DHCP Server, otherwise select [Fixed IP Address].
For [Fixed IP Address], enter an unused address from
the range used on your LAN, or click the [Suggest New
Values] Button.
Use the same [Network Mask] and [Gateway] as PCs
on your LAN.
To install the Wizard on your PC, use the
[Installation] option.
The Error LED should be OFF and the ACT LED should
be ON or flashing.
The LAN LED should be ON.
For the configuration TCP/IP protocol has to be used.