Ricoh Aficio 3224C Operating Instructions Manual page 25

Note
❒ To receive a message sent by De-
fault ID Polling Transmission or ID
Override Polling Transmission, it
is necessary to specify the same
Polling ID as the sender's. Free
Polling Transmission does not re-
quire the same Polling ID.
❒ Polling RX Result Report allows
you to verify Polling Reception has
taken place. See p.16 "Polling Re-
sult Report". If E-mail TX Results
is programmed in a Quick Opera-
tion key, you can select whether a
report e-mail is sent after recep-
tion. The destination of this report
can be selected from the e-mail ad-
dresses in the destination list.
❒ You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit steps A and D. See
p.142 "General Settings/Adjust-
ment".
A A A A
Press [Transmission Mode].
B B B B
Press [Polling RX].
C C C C
Depending on which method you
are using, select one of the follow-
ing procedures:
Default ID/Free Polling Reception
A Check that [Default ID / Free Poll-
ing RX] is selected, and then
press [OK].
The [Polling RX] is highlighted,
and the [Default ID / Free Polling
RX] is displayed.
Note
❒ To cancel Polling Reception,
press [Cancel]. The display
returns to that of step
ID Override Polling Reception
A Select [ID Override Polling Recep-
tion].
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F], and then press
[OK].
"ID Override" and the entered
Polling ID are shown above the
highlighted [Polling RX].
Polling Reception
1
B
.
15