Ricoh Aficio 3224C Operating Instructions Manual page 22

Transmission Mode
❒ Polling TX Clear Report allows
you to verify Polling Transmission
has taken place. See p.13 "Polling
Transmission Clear Report". If E-
mail TX Results is programmed in
1
a Quick Operation key, you can se-
lect whether a report e-mail is sent
after transmission. The destination
of this report can be selected from
the e-mail addresses in the destina-
tion list.
❒ You can program one of the Quick
Operation keys with operations for
this function. Using this key allows
you to omit steps B and G. See
p.142 "General Settings/Adjust-
ment".
❒ The communication fee is charged
to the receiver.
A A A A
Place the original, and then select
the scan settings you require.
Reference
p.13 "Placing Originals", Fac-
simile Reference <Basic Features>
p.29 "Scan Settings", Facsimile
Reference <Basic Features>
B B B B
Press [Transmission Mode].
C C C C
Press [Polling TX].
12
D D D D
Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
Free Polling Transmission
A Check that [Free Polling TX] is se-
lected.
Default ID Transmission
A Select [Default ID TX].
ID Override Transmission
A Select [ID Override Transmission].
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F].
Note
❒ A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
❒ If you make a mistake, press
[Clear] or the { { { { Clear/Stop} } } } key,
and then try again.