Switch Rear Panel - Interlogix GE-DS Series User Manual

Switch Rear Panel

The rear panel of the Managed Switch indicates an AC inlet power socket, which works with input power range from 100 to
240V AC, 50-60Hz. Figure 2-7
GE-DS-82 Rear Panel
GE-DS-82-POE and NS2503-8P/2C Rear Panel
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information includes IP Address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users an run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm
and so on) to enter the startup screen of the device.
1. The device requires a power connection to operate. If your networks should active all the time,
please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you
from network data loss or network downtime.
Power Notice:
2. For additional protection against unregulated voltage or current surges, you may also want to
consider surge suppression as part of your installation.
to Figure 2-8 shows the rear panel of the Switch.
Figure 2-7: GE-DS-82 rear panel.
Figure 2-8: GE-DS-82-POE and NS2503-8P/2C rear panel
GE-DS-82 and NS2503-8P/2C Series User Manual
18