Reboot Switch; Reset To Default; Tftp Update Firmware; Restore Configure File - Interlogix GE-DS Series User Manual

If you set this command, the switch will reboot.
show dhcp
Description:
show dhcp enable/disable.

Reboot switch

boot
Description:
Reboot (warm-start) the switch.

Reset to Default

erase startup-config
Description:
Reset configurations to default factory settings at next boot time.

TFTP Update Firmware

copy tftp firmware
Description:
Download firmware from TFTP server.
Syntax:
copy tftp firmware <ip-addr> <remote-file>
Parameters:
<ip-addr> specifies the IP address of the TFTP server.
<remote-file> specifies the file to be downloaded from the TFTP server.

Restore Configure File

copy tftp <running-config | flash>
Description:
Retrieve configuration from the TFTP server. If the remote file is the text file of CLI commands, use the keyword
running-config.
If the remote file is the configuration flash image of the switch instead, use the keyword flash.
Syntax:
copy tftp <running-config | flash> <ip-addr> <remote-file>
Parameters:
<ip-addr> specifies the IP address of the TFTP server.
<remote-file> specifies the file to be downloaded from the TFTP server.

Backup Configure File

copy <running-config | flash> tftp
Description:
Send configuration to the TFTP server. If you want to save the configuration in a text file of CLI commands, use the
GE-DS-82 and NS2503-8P/2C Series User Manual
158