Commands Level - Interlogix GE-DS Series User Manual

Commands Level

The following table lists the CLI commands and description.
Modes Access Method
Begin a session
User EXEC
with your switch.
Enter the enable
Privileged
command while in
EXEC
User EXEC mode.
Enter the configure
command while in
Global
privileged EXEC
Configuration
mode.
GE-DS-82 and NS2503-8P/2C Series User Manual
Prompt Exit Method
Enter logout or
switch>
quit.
Enter disable to
switch#
exit.
To exit to
privileged EXEC
switch (config)#
mode, enter exit
or end
144
About This Mode1
The user commands available
at the user level are a subset of
those available at the
privileged level.
Use this mode to:
• Perform basic tests.
• Display system information.
The privileged command is the
advanced mode.
Use this mode to
• Display advanced function
status
• Save configuration
Use this mode to configure
those parameters that are
going to be applied to your
switch.