Led Indications - Interlogix GE-DS Series User Manual

■ Reset button
On the left portion of front panel, the reset button is designed for rebooting the Managed Switch without a power cycle. The
following is the summary table of Reset button functions:
Reset Button Pressed and Released
About 1~3 second
Until the PWR LED lit off

LED Indications

The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed.
GE-DS-82 LED indication

System
LED Color
PWR Green

Per 10/100Base-TX RJ-45 port
LED Color
LNK/ACT Green
100 Orange
Function
Reboot the Managed Switch
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
。
。
。
Figure 2-4: GE-DS-82 LED panel
Illuminates to indicate that the Switch has power.
Illuminates to indicate the link through that port is successfully established.
Blink to indicate that the Switch is actively sending or receiving data over that port.
Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps.
GE-DS-82 and NS2503-8P/2C Series User Manual
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
Function
Function
15