Table of Contents
Advertisement
CONSOLE MANAGEMENT
The IFS GE-DS-82 and NS2503-8P/2C series is equipped with a RS-232 DB9 connector as default. And both of the two models
support telnet management.
Login in the Console Interface
To configure the system via console mode, connect a serial cable to a COM port on a PC or notebook computer and to RJ-45
type serial (console) port of the Managed Switch. The console port of the Managed Switch is DCE already, so that you can
connect the console port directly through PC without the need of Null Modem.
Please refer to
chapter 3.5- Administration Console
GE-DS-82-POE with HyperTerminal on Microsoft Windows platform.
Once the terminal has connected to the device, power on the GE-DS-82-POE, the terminal will display that it is running testing
procedures.
Then, the following message asks the login password. The factory default password as following and the login screen in
5-1
appears.
Username: admin
Password: admin
1.
For security reason, please change and memorize the new username and password after this
first setup.
Username Max: 6, Min: 1 characters.
Password Max: 6, Min: 1 characters.
2.
Only accept command in lowercase letter under console interface.
GE-DS-82 and NS2503-8P/2C Series User Manual
to get more information about how to connect to the console interface of
Figure 5-1: GE-DS-82 Console Login screen
141
Figure
Advertisement
Table of Contents
