Table of Contents
Advertisement
Port-based VLAN
Packets can go among only members of the same VLAN group. Note all unselected ports are treated as belonging to another
single VLAN. If the port-based VLAN enabled, the VLAN-tagging is ignored.
In order for an end station to send packets to different VLANs, it itself has to be either capable of tagging packets it sends with
VLAN tags or attached to a VLAN-aware bridge that is capable of classifying and tagging the packet with different VLAN ID
based on not only default PVID but also other information about the packet, such as the protocol.
Create a VLAN and add member ports to it
1.
Click the hyperlink "VLAN" \ "Static VLAN" to enter the VLAN configuration interface.
2.
Select "Port Based VLAN" at the VLAN Operation Mode, to enable the port-based VLAN function.
3.
Click "Add "to create a new VLAN group. Then the following Figure 4-4-3 appears.
4.
Type a name and Group ID for the new VLAN, the available range is 2-4094.
5.
From the Available ports box, select ports to add to the Managed Switch and click "Add".
6.
Click Apply.
7.
You will see the VLAN Group displays.
8.
If the port-based VLAN groups list over one page, please click "Next Page" to view other VLAN groups on other page.
9.
Use "Delete" button to delete unwanted port-based VLAN groups
10.
Use "Edit" button to modify existing port-based VLAN groups.
GE-DS-82 and NS2503-8P/2C Series User Manual
Figure 4-4-2: Port-based VLAN interface
67
Advertisement
Table of Contents
