Parameter Structure - Omron E5GC User Manual

7-2

Parameter Structure

• To execute user calibration, enter the password "1201" at the Move to Calibration Level parameter in
the Advanced Function Setting Level. The mode will be changed to the calibration mode, and adj will
be displayed.
• The Move to Calibration Level parameter may not be displayed when the user is doing the calibration
for the first time. If this happens, set the Initial Setting/Communications Protect parameter in the
Protect Level to 0 before moving to the Advanced Function Setting Level.
• The calibration mode is ended by turning the power OFF.
• The parameter calibrations in the calibration mode are structured as shown below.
Advanced Function
Setting Level
adj
30
Resistance
thermometer
M
0: Pt100 1: Pt100
2: Pt100
3: JPt100
4: JPt100
p390 p280
e20c e26b
M M
p 10 p 10
4543 4543
M M
str
no
M
Transfer output
*This function is displayed only for a Digital Controller that has a transfer
output. The E5CC-U, E5DC, and E5GC do not have a transfer output.
calibration
When calibration has been performed after purchase, the user calibration information shown in the
following illustration will be displayed when moving to the Calibration Level.
E5@C Digital Temperature Controllers User's Manual (H174)
Display moves automatically according to input type.
Current
Thermocouple or infrared
input
temperature sensor
5: K
25: 4 to 20 mA
7: J
26: 0 to 20 mA
11: E
12: L
15: N
19: W
20: PLII
t 54 t 24 a 20
b9a5 e220 c8e7
M M
t -6 t -6 a
2988 0200 4677
M M
bia5 bia5
35b8 35b8
M M
.adj
Voltage input
27: 1 to 5 V 29: 0 to 10 V
28: 0 to 5 V
1V 5 2V10
c7c3 b104
M M M
1 1V 1 2V 1
5ac0 4ad9
M M M
30
A dot is displayed.
7 User Calibration
6: K
8: J
9,10: T
13,14: U
16: R
17: S
18: B
21: K140F/60C
22: K240F/120C
23: K280F/140C
24: K440F/220C
30: 0 to 50 mV*1
*This range can be used only for
E5CC-U Digital Controllers and only
if they are manufactured in May
2014 or later (version 2.2 or higher).
t 54
b9a5
M
t -6
2988
M
7
7 - 3