Omron E5GC User Manual page 50

2 Preparations
Drawing Out the Interior Body of the E5GC to Replace It
You can use the Y92F-55 Draw-out Jig to remove the interior body of the Digital Controller from the case to
perform maintenance without removing the terminal leads. This is possible for only the E5GC. Check the
specifications of the case and Digital Controller before removing the interior body from the case.
1. Drawing Out the Interior Body from the Rear Case
(1) Slowly insert the Draw-out Jig into the Draw-out Jig insertion holes laterally until it clicks into
place. (There is a hole at both the top and bottom.) (If you attempt to draw out the interior
body of the Digital Controller when only one hook is engaged, the Digital Controller may be
damaged.)
Draw-out Jig
(2)
(2) Pull out the Draw-out Jig together with the front panel. Do not pull with excessive force.
Slowly pull out the Digital Controller laterally. (If you pull the interior body out at an angle,
the Digital Controller may be damaged.)
(3) After the interior body is free from the rear case, support the interior body with one hand
and draw it out slowly in a horizontal direction.
2 - 14
Rear case
Front panel
(1)
(1)
Draw-out Jig insertion holes
Draw-out Jig insertion holes
Hook
E5@C Digital Temperature Controllers User's Manual (H174)